HM 8-500K

Crane-fed HEIZOHACK wood chippers are powerful professional machines for contract companies or cooperatives. HEIZOHACK chippers allow all wood waste such as slats, edges, firewood, slabs, pruning cuts and entire trunks with a diameter of up to approximately 80cm to be chipped up with little energy. A powerful steel track belt and a contact roller with welded spikes ensure the material is fed in reliably. All functions of the crane-fed chipper can be controlled hydraulically. Crane fed chipper on single or tandem axle with or without crane Feed: - Pressure roller with steel teeth (Ø 800 mm) - Conveyor belt 900 mm long - In-feed table 1.500 mm long Feed Flap: - Hydraulically foldable - Front end roller at the in-feed table - Optional infeed conveyor belt Sieve: Standard Mesh 45/60mm Drum Ø: 495 mm with quick change blades Flywheel: 1.000 kg Ejector: - Hydraulically foldable, adjustable for height and rotatable (Ejecting height approx. 3.35 m up to 4.25 m; depending on chassis and tyres) - Hydraulic ejector flap adjustment Controls: - Automatic load-dependent feed controls - Two day counters and one overall operating hours counter - Feed speed infinitely variable - Feed direction reversible - Remote Control with 10 m cable and control panel for all functions Drive: PTO shaft and V belt transmission Drive rpm: max. 1.000 min-1 Drive Power: max. permissible 170 KW / 230 PS Chassis options: Chassis 40km/h Trailing axle, spring-loaded pneumatic brake, PTO, supporting leg,. Drawbar and trailer coupling ring Ø40 mm, wings and lighting, without tyres, with ABE Permissible total weight: 9.000 kg Height of towing port: 500 mm Weight: 1.000 kg Tyres: Tyres 385/55 R22.5 up to 80 km/h, Road tyres Tyres 400/55 R22.5 up to 40 km/h, Off-road tyres Tyres 500/45 R22.5 up to 40 km/h; Off-road tyres (only for chassis 04-310-715, not for crane set-up HM 8-500K) Vehicle width: approx. 2,80 m The Powered In-feed table allows better transfer of wood into the chipper particularly short pieces or brash. Also due to small gap between powered In-feed table and the lower in-feed bed dirt and small debris can fall through. We can mount a standard agricultural pick-up hitch to the rear of a chipper for standard UK pick-up hitch trailers. Operation is via the main chipper control panel and changeover switch. We build special application chassis with options for higher road speed and better ground clearance and travel over soft ground. We have designed and built several bespoke chassis for these chippers incorporating kronos cranes along with other options such as crane mounted cabin.